Golf Cart Rear Seat Bag Holder Bracket Attachment for Most 2+2 Golf Cart Rear Seats, No-Drilling - 10L0L

Easy to install :

1-5 Insert the middle structural member with the left and right side, aligning the position with the matching frame section. Take out the large 50mm screws and align them with the screw holes in the middle structural member. Use two 14mm spanners to tighten them. Next, measure the width of the rear seat armrest on both sides and adjust the length of the frame part to fit the armrest correctly.

6 Tighten both ends with two convenient screws.

7 Fix the attachment part onto the frame with a 49mm screwdriver,

8 Tighten the screw with a 10mm wrench

9 Fix the right side onto the frame with the same method

10-11 Match the holds on the reinforcement iron plate, tighten the 24mm screw with a 10mm wrench and 4.4mm torx key

12-13 Drill through the rubber layer with a universal key or pointed awl, tighten the 24 mm screw in the middle of the gasket to secure the rubber layer, and drill holes to match the holes by similarly drilling through the rubber layer at the outer ends of the two ends near the rubber layer

14 The complete universal golf bag holder is successfully installed and safe to use, and can be uninstalled when you don't need it.